The image below is a link. Try to click on it.

Irdroid serial IR cable specifications and description

The irdroid serial cable Kit , is a inexpensive serial (RS-232) device that allows you to capture IR remotes data. The Serial cable kit does not have any decoding logic. All the infrared signal decoding is performed via the irrecord application , which is part of the LIRC project.  In the Gallery below the schematics, and the pcb layout files of the Irdroid serial IR cable kit are provided.

The following is required to build the kit:

  • Soldering Iron
  • FTP flexible cable or any other cable with 6 wires
  • DB9 RS-232 connector

The Kit contains the following components:

1.PCB  0217– 1 pcs.
2. U1

IR Receiver TSOP1838

SFH5110-38 or PNA4612M– 1 pcs.
3. VD1,2Diode double BAY70 SMD– 1 pcs.
4. VD3Zener diode 5,1V– 1 pcs.
5. VD4LED F3

– 1 pcs.

6. С1capacitor 22µF/6,3V– 1 pcs..
7. R1resistor 910 (820)Ω– 1 pcs.
8. R2resistor 1,8 (2,2)kΩ– 1 pcs.
9. R3resistor 4,7 (3,3)kΩ– 1 pcs.
10.Enclosure Canon DB 9 / front plate– 1 pcs.

The Serial Ir receiver is to be connected to a unused RS-232 (serial) port of your computer and it is power supplied from the serial port. For this purpose the lines RTS and DTR are used. The Signal lines RTS and DTR are established in a level “0” state, this level (in the RS-232 standard) corresponds to a voltage of +10 volts. The Zener diode VD3 limits this voltage to 5 volts, which is needed for the proper function of the infrared receiver IC. The Capacitor C1 has a filtering function. The Infrared receiver module U1 is a specialized IC, which amplifies the infrared signals and demodulates them. The carrier frequency between 30 and 50khz (most commonly used 38khz) is used.  Depending on wheather there is a carrier frequency emitted or not, the output pin of U1 generates voltages which corespond to logical “0” and logical “1” . These bits are then transfered to the DCD line of the RS-232 and it is further decoded by the software installed in the PC. Most of the Software solutions that work with the infrared receiver module allows for choosing of the line which carries the data. In our case it is the DCD line.The cable lenght of the receiver should not be longer than 2 meters ( a limitation of the RS-232 ).

For information regarding the software used to capture IR codes please refer to this article:

https://irdroid.com/2013/02/recording-ir-remotes-using-inexpensive-ir-receiver-device/

 

 

You could purchase irdroid serial IR receiver from the DIY section below :

[print_thumbnail_slider]

The image below is a link. Try to click on it.

Interactive Irdroid handbook

This small handbook is an effort to describe in detail the Irdroid project – an open source, open hardware infrared remote control for the Google’s Android operating system. Discover how to: – Customize the Irdroid source code – Setup you Android Development Environment. – Configure the Android Emulator. – Make a custom Infrared module for you Android phone. – Make your own Android infrared control APP.

Click on the image below to browse the Irdroid handbook

 

Irdroid HandBook

Irdroid HandBook


 
[mailchimpsf_form]